You have entered the following information: To change an answer, enter the step number to return to or hit to save changes and exit. Note that password characters are not printed. Then confirm the password by re-entering it. To avoid illegal access to the machine, please type a password and then press. Step 6: Admin password (Press to leave unchanged)? Step 6: Confirm admin password? Step 5: Enable DHCPv6 on mgmt0 interface? This turns on auto-configuration of the IPv6 addresses. Step 4: Enable IPv6 auto-config (SLAAC) on mgmt0 interface? If you enter 'no' (no IPv6), you will automatically be referred to Step 6. The management interface will be able to use IPv6 addresses. If you enter ‘no’ (no Zeroconf), you must enter a static IP, and the session will continue. If you type ‘no’ (no DHCP), then you will be asked whether you wish to use the ‘zeroconf’ configuration or not. If you wish the DHCP server to assign the IP address, type ‘yes’ and press. (mgmt0 is the management port of the system). Perform this step to obtain an IP address for the system. Otherwise, type a different hostname and press. If you wish to accept the default hostname, press.

You must perform this configuration the first time you operate the system or after resetting the system. NVIDIA configuration wizard Do you want to use the wizard for initial configuration? yes Once you perform that, you should get the CLI prompt of the system. Configure a serial terminal program (for example, HyperTerminal, minicom, or Tera Term) on your host PC with the settings described in the table below. Make sure to connect to the Console RJ45 port and not to the (Ethernet) MGT ( ) port. Connect a host PC to the Console RJ45 ( ) port of the system, using the supplied harness cable (DB9 to RJ45). To perform initial configuration of the system: In case a manual configuration is required, please refer to the instructions in Manual Host Configuration.

If you wish to disable it, refer to Disable Dynamic Host Configuration Protocol (DHCP). The system comes with a pre-configured DHCP. The procedures described in this chapter assume that you have already installed and powered on the system according to the instructions in this document. Configuring Network Attributes Using NVIDIA Onyx (MLNX-OS) For bring-up of a switch system with NVIDIA Onyx (MLNX-OS) operating system installed, see Configuring Network Attributes Using NVIDIA Onyx (MLNX-OS).įor bring-up of a switch system with Cumulus Linux operating system installed, see Configuring Network Attributes Using Cumulus Linux.

Linux ip over serial port